Nobody filled a pool, the kids weren’t home for half the month, and the water bill still went up. Or maybe it’s a sound: a faint hiss from the hallway at night when every tap is closed. This guide shows you how to find a water leak in your house in the order that wastes the least time, starting with the one test that tells you whether there is a leak at all.
It’s worth the effort. The EPA’s WaterSense program estimates the average household’s leaks waste more than 9,300 gallons a year, and that 9 percent of homes have leaks losing 50 gallons or more every day. Most of those leaks are small, fixable and sitting somewhere you can check with a flashlight.

Step 1: Let the Water Meter Answer the First Question
Before you start pulling out appliances, find out whether water is actually moving through your plumbing when it shouldn't be. Your water meter answers that in a few minutes.
Find the meter. In the Las Vegas Valley Water District's service area, most residential meters sit in a box near the front yard, usually close to the sidewalk or curb, with a lid marked "Water" or "LVVWD" according to the district's meter page. Lift the lid carefully. Desert meter boxes are a favorite spot for spiders, so a screwdriver and a flashlight beat bare hands.
Shut everything off. Turn off every faucet, make sure the dishwasher, washing machine and ice maker aren't filling, and switch the irrigation controller off or to rain mode. A single sprinkler zone running will fool the whole test.
Watch the flow indicator. Most meters have a small red or white triangle or a dial that spins whenever water passes through. The LVVWD's leak guide says if that indicator keeps moving with all water off, you may have a leak.
Run the slow version for small leaks. A tiny drip may not turn the indicator enough to see. Write down the full meter reading, avoid using any water for two hours (the timeframe WaterSense suggests), then read it again. Any change means water is escaping somewhere.
Split the house from the yard. Now close your home's main shutoff valve, usually on an outside wall near the front of the house or in the garage, and look at the meter again. If the indicator stops, the leak is inside the house. If it keeps moving, the leak is most likely underground, in the line between the meter and the shutoff.
Check the sprinklers separately. In many Valley homes the irrigation line branches off before the house shutoff. With the house shutoff open, close the valves to the irrigation system. If the indicator stops moving only when the irrigation is off, the leak is in the sprinkler or drip system rather than your home's plumbing.
Write all of this down, including the times. It gives you, or a plumber, a head start on everything that follows.
Step 2: Put Food Coloring in Every Toilet Tank
If the meter says the leak is inside, toilets are the first suspect. The Southern Nevada Water Authority notes that more than 20 percent of toilets have a leak, and because the water slips straight down the drain, you never see a puddle.
Take the lid off the tank and add a few drops of food coloring. Don't flush. Come back in about 10 minutes. Color in the bowl means the flapper isn't sealing and water is trickling through. Flush afterward so the dye doesn't stain the tank.
While the lid is off, look at the water level. If it sits above the top of the overflow tube, the fill valve is the problem instead, and water is running down that tube all day. A toilet that refills by itself every so often with nobody using it is showing the same symptom. Our guide to a toilet that keeps running walks through both repairs.
Finally, feel the floor around the base. A wax ring that has failed leaks only when the toilet is flushed, so it won't show on the meter, but it can rot the subfloor over months.
Step 3: Work Through the Supply Lines Under Sinks and Behind Appliances
Every fixture in your home connects to the plumbing with a short supply line and a small shutoff valve, and those connections fail far more often than the pipes themselves.
Open each sink cabinet, empty it, and run a dry paper towel along the supply lines, the valve stems and the drain connections. A paper towel picks up dampness your fingers miss. In Las Vegas, white or greenish crust on a fitting is a giveaway: our very hard water leaves mineral deposits wherever a slow drip evaporates.
Then move to the appliances:
- Washing machine. Pull it forward and check both hoses along their length and at each end. Bulges, cracks and rusty fittings are all reasons to replace a hose before it bursts.
- Refrigerator. The ice maker line is often thin plastic tubing that kinks or splits behind the fridge where nobody looks for years.
- Dishwasher. Remove the kick plate at the bottom and shine a light underneath at the supply connection. A dishwasher drips onto the floor long before it soaks through the cabinet.
Don't forget outdoor hose bibs. A handle that drips at the stem leaks every hour of the day.
Step 4: Give the Water Heater a Close Look
In many Las Vegas Valley homes the water heater sits in the garage, which makes a slow leak easy to miss. Look for water or rust stains on the floor, crust on the pipe connections at the top, and moisture at the drain valve near the bottom.
Pay attention to the temperature and pressure relief valve, the brass valve with a pipe running down the side of the tank. That pipe should be dry. Steady dripping or flow from it means the valve is opening, which can point to excess pressure or temperature, or a valve that is wearing out. Never cap, plug or adjust it. It's a safety device, and a technician should find out why it's discharging. If you find water pooling under the tank itself, rather than at a fitting, the tank is usually failing. A water heater repair visit will tell you which one you're dealing with.
One more trick for later: if the water heater keeps firing up when nobody has used hot water, that's a strong hint the leak is somewhere on the hot side of your plumbing.
Step 5: Narrow Down a Leak Under the Slab
Almost every home in the Valley sits on a concrete slab, and many have water lines running under or through it. If the meter shows water moving inside the house and the toilets, fixtures and appliances are all dry, the slab moves up the list.
Clues worth noting:
- A warm patch on tile or concrete you can feel with bare feet
- The sound of running water near a wall or floor with everything shut off
- Damp carpet or a swelling floorboard with no plumbing above it
- Cracks in tile or a sudden change in water pressure
One more test can tell you which side of the plumbing is leaking. Close the cold-water inlet valve on top of the water heater, leaving the main open, and go back out to the meter. A triangle that has gone still suggests the leak is on the hot-water side. If you're not sure which valve is which, skip this step and pass along what you've found so far.
None of these clues tell you exactly where the pipe is broken, though, and guessing with a hammer drill is the most expensive way to find out. Leave any digging or concrete work to a licensed plumber.
Step 6: Bring In Leak Detection When the Trail Goes Cold
There's a point where flashlights and paper towels stop helping. If the meter shows a leak and you can't find it, or the evidence points behind a wall, under the slab or out in the yard, professional leak detection takes over.
People often ask how plumbers find leaks without tearing up half the house. It's mostly listening and measuring:
- Acoustic equipment picks up the hiss of water escaping a pressurized pipe through concrete, tile or soil, getting louder as the technician moves closer to the source.
- Pressure testing isolates sections of plumbing, such as the hot side, cold side or the yard line, to show which one is losing pressure.
- Thermal imaging shows the temperature pattern of a hot-water leak spreading under a floor or behind drywall.
Used together, they let a technician mark a small spot before anything is opened. That means one access point instead of several exploratory holes, and less flooring or drywall to replace afterward. Your meter notes and test results make that process faster, so have them ready.
When to Stop Searching and Shut the Water Off
If water is spraying, pooling or coming through a ceiling, finding the source can wait. Close the main shutoff, turn off power to any area where water is near outlets or appliances, and keep clear of a ceiling that is sagging. Our page on what to do if a pipe bursts covers the first hour, and photos of the damage are worth taking before you clean up.
Finding the Leak You Can't See
The meter test, a few drops of food coloring and an hour with a flashlight solve most household leaks. When they don't, Dr. Cool can pinpoint the rest with professional water leak detection. Book online or call (702) 873-1800, and if water is actively flowing, emergency service is available 24/7.
Connect With Us
Our Contact Information
Reach Us by Phone or Email
If you prefer to speak directly with one of our technicians, don’t hesitate to contact us by phone or email. We’re available to assist you during business hours
Phone: (702) 873-1800
Email: info@drcoolservices.com
Business Hours:
Mon – Fri: 7:00 am – 9:00 pm
Sat – Sun: 8:00 am – 5:00 pm